Back to home page

DOS ain't dead

Forum index page

Log in | Register

Search:  
Back to the forum
Board view  Mix view

USBexFAT ASPI DISK DRIVER Ver 1.0a released (Announce)

posted by roytam, 06.01.2011, 13:32

> > for the USB keyboard/mouse, did they work when USBASPI is not loaded? If
> > so, add "/norst" argument in USBASPI line.
>
> /norst didn't help, even with original driver
>
> > EDIT: Message from yaya:
> > You may try with original USBASPI as with this hacked USBASPI, some USB
> > classes may be not supported.
>
> I tried original driver at home and it also reported some errors (btw much
> slower detection):
>
>
> ASPI Manager for USB mass-storage  Version 2.27                         
> (C)Copyright Panasonic Communications Co., Ltd. 2000-2008
>
>
> ERROR : Target USB device not found.
> ERROR : Driver resides since USB FDD was detected.
> 1 char device installed.
> Driver loaded.
> USBexFAT ASPI DISK DRIVER Ver 1.0a. FANJIANYE create in 2011/01/02
>
> ASPI Manager not installed.
>
>
> But it works! I didn't specified drive letter and it replaced my std.
> floppy A: with USB A: I think it would be better if it scan BIOS data for
> real floppy first and then assign it as drive B:
> So I think that patching of the USBASPI.SYS should be done carefully to not
> break support for some devices. Here's some info about this USB FDD:
>
>
> Device Descriptor:
> bcdUSB:             0x0110
> bDeviceClass:         0x00
> bDeviceSubClass:      0x00
> bDeviceProtocol:      0x00
> bMaxPacketSize0:      0x08 (8)
> idVendor:           0x054C (Sony Corp.)
> idProduct:          0x002C
> bcdDevice:          0x0501
> iManufacturer:        0x01
> iProduct:             0x02
> iSerialNumber:        0x00
> bNumConfigurations:   0x01
>
> ConnectionStatus: DeviceConnected
> Current Config Value: 0x01
> Device Bus Speed:     Full
> Device Address:       0x02
> Open Pipes:              3
>
> Endpoint Descriptor:
> bEndpointAddress:     0x81  IN
> Transfer Type:        Bulk
> wMaxPacketSize:     0x0040 (64)
> bInterval:            0x00
>
> Endpoint Descriptor:
> bEndpointAddress:     0x02  OUT
> Transfer Type:        Bulk
> wMaxPacketSize:     0x0040 (64)
> bInterval:            0x00
>
> Endpoint Descriptor:
> bEndpointAddress:     0x83  IN
> Transfer Type:   Interrupt
> wMaxPacketSize:     0x0002 (2)
> bInterval:            0x10
>

Both USBASPI and USBEXFAT are not loaded actually, the emulation by BIOS is in work.

Post reply
 

Complete thread:

Back to the forum
Board view  Mix view
22781 Postings in 2123 Threads, 402 registered users (0 online)
DOS ain't dead | Admin contact
RSS Feed
powered by my little forum