Back to home page

DOS ain't dead

Forum index page

Log in | Register

Back to the forum
Board view  Mix view

Problems with new CF card in HP OmniBook 800 (Users)

posted by rr Homepage E-mail, Berlin, Germany, 02.05.2020, 22:58

> Yes, CF geometry may cause problems to DOS when there is some mismatch. Try
> to boot some other disk partitioning tool and creare new partitions on CF.
> Or wipe the CF MBR completly and let fdisk to make new partitions - if it
> will boot...

1) I wrote a 10M MS-DOS HDD installation completed in Bochs to the CF card. No boot from CF or MS-DOS floppy possible.
2) So, yes, I wiped the MBR on several ways. Like in 1) or by filling first 512 bytes with 0. (HxD on Windows helped here.)
3) I still found no way to boot MS-DOS, when I create a partition with FDISK. When exiting FDISK, you have to reboot. Afterwards it hangs booting from floppy again.

I also had some mail exchange with Eric Auer, which was at least a little help, but I gave up meanwhile. I will now just use a 2GB CF card from maxflash, which works fine. I already bought six used 1GB cards from the same brand on eBay for cheap.

---
Forum admin

 

Complete thread:

Back to the forum
Board view  Mix view
22049 Postings in 2034 Threads, 396 registered users, 125 users online (0 registered, 125 guests)
DOS ain't dead | Admin contact
RSS Feed
powered by my little forum