Back to home page

DOS ain't dead

Forum index page

Log in | Register

Back to the forum
Board view  Mix view

Run Linux & Linux binaries on DOS (Announce)

posted by RayeR Homepage, CZ, 03.10.2020, 13:37

It's my main core i7-2600k machine. I put the DSL on sata disk 0 - IDE emulation as primary master, FAT16 formatted partition C: along my DOS. I will check what device name is used in my debian linux for this disk but it might changed as kernel drivers changed. I saw that dsl.com contains some hardcoded paths and parameter, it' not good idea, better to have a separate config file. Now I just tried to boot it on my compaq notebook with standard ide hdd C: and it rebooted my system immediatelly so I couldn't read any error mesage if there was any. To start dsl I just booted to bare msdos 6.22 without config cd to dsllinux and run dsl.com

---
DOS gives me freedom to unlimited HW access.

 

Complete thread:

Back to the forum
Board view  Mix view
22049 Postings in 2034 Threads, 396 registered users, 258 users online (0 registered, 258 guests)
DOS ain't dead | Admin contact
RSS Feed
powered by my little forum