Back to home page

DOS ain't dead

Forum index page

Log in | Register

Back to the forum
Board view  Mix view

AHCICD.SYS alternatives? (Users)

posted by Japheth Homepage, Germany (South), 21.01.2021, 02:55

> Do all ATA commands over AHCI requires use DMA? E.g. ATA identify or
> read/write a single sector? On old (S)ATA there was choice to use DMA
> commands except e.g. TRIM that requres strictly DMA.

There's no port address available in AHCI, so you can talk to the HBA in "DMA terms" only. The real communication between HBA and the device may be a different matter.

> Maybe some SMM magic? What transfer rate you got cca under DOS?

about 125 MB/sec int 13h read speed (using a seagate HD, dated 2013).

To access the memory mapped registers in real-mode I tried to temporarily "remap" the HBA ( by changing PCI config registers ), but that obviously "doesn't work". But the chipset perhaps may offer such an option.

---
MS-DOS forever!

 

Complete thread:

Back to the forum
Board view  Mix view
22049 Postings in 2034 Threads, 396 registered users, 123 users online (0 registered, 123 guests)
DOS ain't dead | Admin contact
RSS Feed
powered by my little forum