Back to home page

DOS ain't dead

Forum index page

Log in | Register

Back to the forum
Board view  Mix view

DOS on Compaq EVO T20 thin client - possible? (Developers)

posted by RayeR Homepage, CZ, 11.11.2008, 16:58

I found a way how to overcome problem with accessing disk image in BOCHS. When I temporarly switch partition type from 04 to 0Eh I can access entire image. But it doesn't work on T-20 because BIOS probably doesn't support LBA INT 13h BIOS extension. Here's my bochsrc.txt for image posted above and error log when hanged accessing sector >969

I did some further experiemnts:
1) I used GRUB4DOS 0.4.4 to boot directly freedos kernel.sys
- failed on init disk phase
[image]
2) I used GRUB4DOS 0.4.4 to load 1,44M FD image with freedos
- failed due to missing INT 15h BIOS service
[image]
3) I used GRUB4DOS 0.4.4 to load memdisk (syslinux 3.72) and
then load 1,44M FD image
- failed with some strange error
[image]
I also tried HDD image harddisk=0 c=150 h=4 s=17 (tested
in bochs) and memdisk loaded it but didn't run, ended
with "loading boots ector... booting..."

I used this hellchain: NTBootSector->NTLDR->GRLDR->MEMDISK->kernel|image

Maybe the only way will be compile own FD kernel with HDD geometry hardcoded...

---
DOS gives me freedom to unlimited HW access.

 

Complete thread:

Back to the forum
Board view  Mix view
22049 Postings in 2034 Threads, 396 registered users, 260 users online (1 registered, 259 guests)
DOS ain't dead | Admin contact
RSS Feed
powered by my little forum