DOS ain't dead

> DOS64 version - it works great for me from DOS with JEMM, I have currently
> 8GB RAM installed. It wouldn't work with 4GB or less? (even with 4GB RAM
> installed there is some RAM beyond 4GB remapped from PCI MMIO, so I had
> about 4,5GB before when used 2*2GB modules)
>
> I noticed there appeared a "NDN" bottom line below F-bar, why is this for
> (it just displays info about NDN)? It just waste one line that could
> display files in panel, how can I hide it? (was not present in previous
> version)
>
> BTW what are advantages of NDN64 over 32? Where it can use more memory?
> Maybe editing extra large files but I'm already limited by FAT16/32...

The Dos64 version will (should) work if you have any memory beyond 4GB.

The line you wrote about is the hints bar. The fact is that one line is wasted, but only when you have a video mode with a small number of lines. In Windows, for example, I have the mode set to 237x62 (columns x rows) and then it doesn't matter much. To get rid of it select in Menu->Options->Configuration->Interface...->Others->[x]Hide hints bar

The advantages of the NDN64 version are a 256-bit big calculator (to check the bitness of any calculator type "bsr (-1)"), the ability to view and "decode" (see Menu->File->Decoder) large files (>2GB - mainly Windows),
more memory (uses a lot of editor with syntax highlighting turned on - see ndn.hgl file).
In 64-bit mode, CPU registers are twice as long in bits and there are more of them, so NDN should theoretically run faster.

> I still (although slowly) work on the NDN translation to czech languege.
> Are the help files still relevant with this new version?

The old resource files won't work with the new version, but there are a few minor changes that I'm able to make myself using the translator after receiving your translations. Thanks for your work.

CandyMan, i am also stuck with translation.
Due to some problems, i am have no time for (any) open source activity.
I hope return back, when it will be possible.

---
Make DOS great again!

Carthago delenda est, Ceterum censeo Carthaginem delendam esse.

I use similar setup with
HimemSX v3.54 [04/12/22]
Jemm386 v5.84 [02/11/23]
VCPI info:
VCPI version: 1.0
Offset of VCPI entry in protected-mode: 00110674
Start free address space: 00111000
1. VCPI descriptor: 00000000:ffff,cf9b
2. VCPI descriptor: 00000000:ffff,cf93
3. VCPI descriptor: 00000000:0000,0000
highest physical memory address: cf78e000
Free 4K pages: 30716 ( 122864 kB)
CR0: 80000031
DR0-DR3: 00000000 00000000 00000000 00000000
DR6+DR7: ffff0ff0 00000400
Master/Slave PIC base: 8/70
Protected Mode Switch ok

how many phys.RAM do you have?

---
DOS gives me freedom to unlimited HW access.

> NDN says: "D3X: error 0XFB: V86 mode"

By default, the old loader is run, which only works in RAW/XMS mode.

Please take a look at the files with the BAT extension.
There is a TEST.BAT file that replaces the loader with LOADERB.BIN (will run also in V86 mode with DarkDebugger32).
There is also a TESTV86.BAT file that replaces the loader with LOADERBB.BIN (will work also in V86 mode with DarkDebugger32 or installed JEMM).